Page 1
28mm Walkway – Stairs B28-SF-229 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2
Take the right hand stair piece and the steps. Glue the steps into place. Take the walkway and left-hand stair piece. Glue these into position. Attach the rear supports. Then add the front assembly. Take the two cross braces. With the model turned upside down, attach the cross braces to the lugs on the front and rear supports.
Page 3
Glue them into position. Take the armour plates. Glue the into place. The finished model.
Need help?
Do you have a question about the B28-SF-229 and is the answer not in the manual?
Questions and answers