Page 1
28mm Walkway – Triple B28-SF-228 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2
Take the lower barricade section… ..and glue it into position (see pic). Take the upper barricade section… ..and attach that to the model as shown. The rear barricade section. Glue this into place. Leave this “front” assembly to dry. Rear Supports (Do this three times) Take the pieces shown above from the sprue.
Page 3
Attach the three “rear” pieces to the walkway. Take the six cross-braces. Attach each cross-brace between the front and rear Glue the whole model to the base. supports using the lugs. Glue them into position as shown above. Take the armour plates. The finished model.
Need help?
Do you have a question about the B28-SF-228 and is the answer not in the manual?
Questions and answers