BLOTZ B28-ST-105 Instructions

28mm gibbet with target

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due

care and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold

pieces in place while you allow glue to dry.

Gibbet with Target (B28-ST-105)

Remove the two uprights and the base from the

sprue.

Take the two side pieces and the two 'feet' from

the sprue.

Glue one side piece to each side of the uprights,

using the holes/lugs provided.

28mm Gibbet with Target

B28-ST-105

Please read these instructions fully before starting construction.

Glue the two uprights back-to-back, then glue them to

the base (as shown above) using the lugs/holes

provided.

Glue one of the 'feet' to each side piece as shown.

Carefully remove the two brackets from the sprue.

Table of Contents

Need help?

Do you have a question about the B28-ST-105 and is the answer not in the manual?

Page 1 During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while you allow glue to dry. Gibbet with Target (B28-ST-105) Remove the two uprights and the base from the Glue the two uprights back-to-back, then glue them to sprue.
Page 2 Gently slide the two brackets onto the cross Remove the target from the sprue and tie the end of piece as shown. your cord (not supplied) to one of the rings. The finished gibbet and target. Pass the cord through the two brackets (as shown) and then tie off to the other ring on the target.