BLOTZ Old West Store #7 Assembly Instructions Manual

Advertisement

Quick Links

28mm Old West Store #7
B28-OW-114
Assembly Instructions
Designed and made in the UK.
This is a model kit and is not intended for persons
under 14 years old.
Requires assembly. Supplied unpainted.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Old West Store #7 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLOTZ Old West Store #7

  • Page 1 28mm Old West Store #7 B28-OW-114 Assembly Instructions Designed and made in the UK. This is a model kit and is not intended for persons under 14 years old. Requires assembly. Supplied unpainted.
  • Page 2 28mm Old West Front #4 B28-OW-403 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 3 one above the door. Take the door and supports from the sprue. Glue the lower support into place. Allow to dry. Place the lower lug of the door into the lower support, Apply some glue to the upper support and then slide then sit the upper support onto the top lug before it completely into position.
  • Page 4 28mm Old West Rear #2 B28-OW-501 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 5 The insert panels for the end. Glue these into place. Take the door and supports from the sprue. Glue the lower support into place. Allow to dry. Place the lower lug of the door into the lower support, The window sills. then sit the upper support onto the top lug before gently easing it into place (see pic).
  • Page 6 28mm Old West Roof #4 B28-OW-603 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.

This manual is also suitable for:

B28-ow-114

Table of Contents