Advertisement
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The phone part of the box is formed from the three
pieces shown above.
Remove the base and rear wall from the sprue.
Glue the two sides into place. Note the one of the right
has notches cut out of it.
28mm Phone Box #2
B28-ST-127
Please read these instructions fully before starting construction.
Glue the "handset" into place on the back panel,
then glue the keypad into place as shown.
Glue the rear wall to the base, then glue the phone
in front of it. Align the phone using the guide lines
etched into the rear wall.
Glue the roof into place.
Advertisement
Table of Contents
Related Manuals for BLOTZ B28-ST-127
Summary of Contents for BLOTZ B28-ST-127
- Page 1 28mm Phone Box #2 B28-ST-127 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
- Page 2 Glue the two short sections to the roof to form a cross. The glue the upper piece into place. Take the very top section and using a knife / sandpaper, carefully angle the four corners are shown above to form the curved roof. Glue the decorative strips into place around the edge.
Need help?
Do you have a question about the B28-ST-127 and is the answer not in the manual?
Questions and answers