BLOTZ B28-AF-102 Instructions

28mm Wild West Saloon Furniture
B28-AF-102
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Each chair is formed from the pieces shown
above. Apply a little glue to the underside of one
short end of the seat. Stick this to the top of the
bar on the chair back.
Each table is formed from the three pieces shown
Then slide the second pair into position.
above.
Apply glue to the underside of the other end of the
seat and attach the front legs.
First, attach one set of legs a shown above.
The completed table.