28mm Starship Corridor (T-Junction)
B28-STA-104
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Starting with one of the external corner supports,
remove the pieces shown above from the sprue.
Glue the support to the corner of the base using
the lugs provided, then stick the two bottom walls
into position. At this point it's useful (but not
essential) to allow this to dry before proceeding.
Finally glue the decorative pieces into position.
Note that these are flush to the outer edge of the
wall pieces.
Apply a little glue to thinner of the support pieces
and glue it to the wider one as shown above.
Next glue the middle and upper portions of the wall
to the support.
Now repeat this process with the other corner
column.
Need help?
Do you have a question about the B28-STA-104 and is the answer not in the manual?
Questions and answers