BLOTZ B28-SF-226 Instructions

28mm walkway – firing point

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in

place while you allow glue to dry.

Take the two pieces shown above from the sprue.

Take the lower barricade section...

Take the upper barricade section...

The rear barricade section.

28mm Walkway – Firing Point

B28-SF-226

Please read these instructions fully before starting construction.

Glue the one on the right to the back of the one on

the left.

..and glue it into position (see pic).

..and attach that to the model as shown.

Glue this into place. Leave this "front" assembly to

dry.

Table of Contents

Need help?

Do you have a question about the B28-SF-226 and is the answer not in the manual?

Page 1 28mm Walkway – Firing Point B28-SF-226 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 Take the pieces shown above from the sprue. Attach the brackets to the front assembly using the higher end of the bracket. Glue the walkway section into position. Add the rear support piece, with the etched detail facing into the model. Attach the lower end of the brackets to the lugs.