Installation; Notes On Safety For The Installation; Handling; Preliminary Checks - Riello RL 70/E Installation, Use And Maintenance Instructions

4

Installation

4.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
4.2

Handling

The packaging of the burner includes a wooden platform, so it is
possible to move the burner (still packaged) with a transpallet truck
or fork lift truck.
The handling operations for the burner can be highly
dangerous if not carried out with the greatest atten-
tion: keep any unauthorised people at a distance;
check the integrity and suitableness of the available
WARNING
means of handling.
Check also that the area in which you are working is
empty and that there is an adequate escape area
(i.e. a free, safe area to which you can quickly move
if the burner should fall).
When handling, keep the load at not more than 20-
25 cm from the ground.
4.3

Preliminary checks

Checking the consignment
After removing all the packaging, check the integ-
rity of the contents. In the event of doubt, do not
use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must
not be abandoned as they are potential sources
of danger and pollution; they should be collected
and disposed of in the appropriate places.
4.4

Operation position

The burner is designed to operate only in the positions 1, 2, 3 and
4 (Fig. 10).
Installation 1 is preferable, as it is the only one that allows the main-
tenance operations as described in this manual. Installations 2, 3
and 4 permit operation but make maintenance and inspection of
the combustion head more difficult.
Any other position could compromise the correct operation of the
appliance.
Installation 5 is prohibited for safety reasons.
20045163
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manu-
al and in compliance with the standards and reg-
ulations of the laws in force.
WARNING
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
carefully clean all around the area where the burner
will be installed.
CAUTION
The output of the burner must be within the boil-
er's firing rate;
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
WARNING makes any installation or maintenance work diffi-
cult.
1 2
D7739
16 GB
3 4
Fig. 10
5