Installing The Wi-Fi Cable Modem; Connect The Sbg10 To Your Client Device - Arris SURFboard SBG10 User Manual

Installing the Wi-Fi cable modem

Caution: This product is for indoor use only. Do not route the Ethernet cable(s) outside of the
building. Exposure of the cables to lightning could create a safety hazard and damage the
product.

Connect the SBG10 to your client device

Before installing your SBG10:
Check with your service provider (or local cable company) to ensure broadband cable

service is available in your area.
To set up a Wi-Fi network, you will need a high-speed Internet connection provided by an
Internet service provider.
Note: When contacting your service provider, you may need your Wi-Fi cable modem
information listed on the Wi-Fi cable modem label on the bottom of your SBG10 (see
Wi-Fi cable modem label
Choose a location in your home where your computer and Wi-Fi cable modem are

preferably near existing cable and electrical wall outlets.
For the best Wi-Fi coverage, a central location in your home or building is recommended.
Note: The following installation procedure covers the wired Ethernet connection so
that you can confirm that your SBG10 was properly installed and can connect to the
Internet.
PN 365-095-32809 x.1
Copyright 2018, ARRIS Enterprises, LLC. All rights
page 15).
Figure 4: SBG10 connection diagram
reserved.
SURFboard SBG10 Wi-Fi Cable Modem User Guide
Chapter 4
16