Smeg WD1050 Operating Instructions Manual page 37

• the holes in the water spray arms are not clogged;
• nothing is preventing the spray arms from turning.
4. If the instruments fail to dry or remain opaque, make sure that:
• there is neutralizing agent in the relative container;
• the neutralizing agent dispenser has been regulated in the correct way;
• the detergent used is of good quality and has not lost its characteristics (e.g. owing
to incorrect storage, pack left open, etc.).
5. If the instruments are streaked, stained... make sure that:
• the amount of neutralizing agent dispensed is not excessive.
6. If there are visible traces of rust in the washing chamber
• The washing chamber is made of corrosion-proof steel, thus rust stains are due to
external factors (pieces of rust from the water pipes, etc.). Specific products are
available in the shops to eliminate these stains..
• Make sure that the detergent dosage is correct. Some detergents can be more
corrosive than others.
• Make sure that the salt reservoir plug is firmly closed and that the water softener
system has been correctly regulated.
Contact your nearest authorized technical assistance center if the faults persist
after compliance with the instructions given above.
WARNING
Repairs to the appliance by unauthorized personnel are not covered by the warranty
and are at the user's charge.
WD1050 12/04/2010 Pag. 34