Lifting And Handling; Door Locking System - Smeg WD1050 Operating Instructions Manual

T
EMPERATURE
R
ELATIVE HUMIDITY
I
NSTALLATION CATEGORY
C
LASS TO WHICH
APPLIANCE BELONGS
P
OLLUTION DEGREE

4.2. LIFTING AND HANDLING

Before it leaves the factory, the base of the machine is fixed to a pallet
which is then used to lift and transport the machine itself.
The machine must be handled with a fork-lift truck or transpallet.
Do not use appliances damaged by transport! Consult your dealer if in
doubt.
The appliance must only be installed and connected by personnel
authorized by the manufacturer.

4.3. DOOR LOCKING SYSTEM

After unpacking, pay attention to the following:
the machine is equipped with an automatic door locking/unlocking system.
The door is locked. Don't force the door, but follow the procedure below.
Connect the machine to the mains supply;
push the ON/OFF button (in order to switch on the machine)
push (and hold) the button with the symbol of the key and after some seconds the
door opens
°C
► ll
WD1050
80% for temperatures up to 31°C with linear diminut ion down to 50%
IIa
(in compliance with the classification criteria established by DIRECTIVE
SIGNS ON THE FRONT OF THE MACHINE
Door unlocking
Temperature
START / PAUSE
From 5°C to 40°C
at the temperature of 40°C
93/42)
or
12/04/2010
II
2
ON / OFF
Salt Lack
Heating element on
Pag. 7