Machine Running - Smeg WD1050 Operating Instructions Manual

6.4. MACHINE RUNNING

The symbols used below refer to those that appear at the beginning of the par. 6.
The machine is provided with an automatic door locking/unlocking system: to open
the door connect the machine to the mains supply and press the ON/OFF key (3).
The ON/OFF light comes on. At this point, press the key button (6).
Press the ON/OFF key (3) to power the instrument washer on. The "power on"
indicator light will come on.
The door must be shut before any programme can begin. Once the racks have been
filled with the instruments, shut the door and proceed with the following operations.
To activate a washing cycle, select the required programme (P1, ...,P8) using the
knob, then press the START button (4).for a couple of seconds until the characteristic
bip-bip signal is heard.
During the cycle, the display will alternately show the number of the programme
selected and the phase in progress.
The "degrees indicator light" (8) will come on if the temperature key "°C " (5) is
pressed. In this case, the number of the programme in progress and the value of the
temperature in the washing chamber will be displayed alternately.
If you press the temperature key (5) again the corresponding indicator light will come
off and the display will alternately show the number of the programme and phase in
progress.
WARNING
Never open the door whilst the programme is in progress! Despite the fact that the
machine is provided with devices that immediately turn off the washing pump and
heating element, it is absolutely forbidden to open the door when the machine is
operating.
WD1050 12/04/2010 Pag. 19