Printer Language; Operating Instructions - Smeg WD1050 Operating Instructions Manual

• Process of each Phase
• End of Cycle time
• Eventual errors if Cycle terminates incorrectly.
• 'A
': stands for the thermal disinfection effectiveness;
0
In the picture below is shown the serial port (WD1050 back view), which the printer
must be connected to.
fig. 5 – WD1050 back – RS232 PORT (printer connection).

6.13. PRINTER LANGUAGE

How to set the printer language:
• Switch on the machine.
• Turn the programme selector knob to position 6.
• Press the Door Open button ("key" button) for 4 seconds to enter into the setup
function.
• On the display appears "Lx" – "L" stands for language - "x" is a number: "0" for
Italian, "1" for English.
• To increase "x" value press °C.
• To decrease "x" value press ► ll.
• To terminate (programme selector knob to position 6) press the Door Open
button for 4 seconds. The new Printer Language setup is now saved.

7. OPERATING INSTRUCTIONS

After the instrument washer has been correctly installed, it must be prepared for
operation in the following way:
• Pour in regenerating salt (only if necessary, i.e. with water harder than 10°F);
• Add detergent and neutralizing agent.
WD1050 12/04/2010 Pag. 23