Emerson FB1100 Instruction Manual page 52

Emerson FB1100 Flow Computer Instruction Manual
D301752X012
August 2020
1.
2.
3.
48
The operator "awakens" the device by holding a finger against the front cover glass over the
Hold to Wake button (the left-most button) for typically five to ten seconds. You can also
pre-define a number of automatic wake-up times during the day from the Power Control
screen in FBxConnect.
To temporarily keep the HMI module out of sleep mode, maintain an active FBxConnect
connection. So long as communications remain active, the HMI module does not sleep.
Go to the front of the flow computer and touch your finger on the glass above the Hold to
Wake button until the display lights up. (This may take several seconds.)
Figure 3-1: Waking the Display
If prompted, login using a valid username/password combination (Data Entry Mode). For
information on how the buttons work, see
The display enters Screen Saver Mode where it sequentially presents a series of screens
showing details about the meter run flow rates, totals, and current process variables.
Table 3-1.
Operation