Unpacking The Carton; Assemble The Legs - Peak Pilates CASA REFORMER Assembly Manual And Owner's Manual

UNPACK THE CARTON
1
Open the box. Carefully remove all parts and verify that all components and accessories are included.
2
Place protective cover on the floor (so the aluminum frame will not be scratched). With one person at
each end of the reformer, lift the unit out of the box and place on the floor.
WARNING
SINCE NO SPRINGS ARE ATTACHED, THE CARRIAGE IS NOT LOCKED IN POSITION AND MAY
START TO ROLL, BE EXTRA CAUTIOUS WHEN MOVING THE UNIT.
3
Tip the reformer onto its side, exposing the underside of the frame.

ASSEMBLE THE LEGS

4
Attach the foot end leg to the reformer frame
with the footbar positioning plates towards the inside.
Use 8 button head screws with washers and
hand tighten them to the frame.
5
Repeat the process for head end leg (as shown).
6
Go back and fully tighten all screws (torque to 12 ft-lbs
or 16 N-m) with the provided 4mm allen wrench.
PEAK-CASA-OM-2020.indd 9 PEAK-CASA-OM-2020.indd 9
button head screws and washers
(8 each per leg assembly)
www.peakpilates.com 9
4/16/20 8:23 PM 4/16/20 8:23 PM