Table of Contents
Advertisement
CAUTION
Before attempting to use DigiFlow 2000, please
observe the following precautions:
1. When connecting the DigiFlow 2000 to a
flow source, please ensure that the input
pressure does not exceed 20 PSI.
2. Do not use DigiFlow 2000 to measure
gases containing liquid or liquid vapor.
3. Do not exceed the maximum flow range of
the unit. The operational range is indicated
at the back of the unit. In the event of an
over range condition, erroneous readings
will occur and DigiFlow 2000 may require
re-calibration.
4. Do not use DigiFlow 2000 to measure
corrosive gases or H2 gas and He gas.
If any of the above conditions are not
followed and thereby result in damaging the
transducer, repair(s) will not be covered
under Warranty.
DIGIFLOW 2000 USER MANUAL REV 0
Hammer pressure levels in excess of
20 PSI will cause damage to the flow
sensor.
14
Advertisement
Table of Contents
