Advertisement
WARNING! Do not cut or shorten the wiring
harness. If the harness is too long, coil the excess
wire and secure it with plastic wire ties.
3. Connect the red wire to the positive (+) terminal
and the black (grounding) wire to the negative (-)
terminal of the vehicle battery.
WARNING! Before operating the lift, inspect the
wiring harness for proper routing and grounding.
Improper routing can cause damage to the harness,
and improper grounding can cause damage to the
electrical system.
Wheel Chock Installation
Your lift will be supplied with four adjustable wheel
chocks that, when installed, aid in centering your
mobility device during loading.
To install the wheel chocks:
1. Drive your mobility device onto the lift platform,
positioning it as near to the center as possible.
2. Position the wheel chocks on the platform.
Scooters: Place a wheel chock in front of the front
wheel(s) and behind the rear wheels or behind the
front wheels and in front of the rear wheels. Power
Chairs: Place a wheel chock in front of and behind
the drive wheels.
3. Take note of the adjustment holes the wheel chocks
align with on the platform and remove the chocks.
4. Remove the mobility device from the lift platform.
5. Raise the platform high enough to be able to install
hardware from under it.
6. Position the wheel chock bottom on the underside
of the platform, aligning it with the wheel chock
top. See figure 11.
7. Secure the wheel chock sections to the platform
using the supplied hardware. See figure 11.
8. Repeat these steps to install the remaining wheel
chocks to the lift platform.
NOTE: The Outlander TM and do not require wheel
chock installation. The platform designs support
the mobilty device wheels so that wheel chocks
are not required. See figure 12.
14
I I I . I N S TA L L AT I O N
www.harmar.com
WHEEL CHOCK TOP
WHEEL CHOCK BOTTOM
SCREWS
Figure 11. Wheel Chock Installation
Figure 12. Wheel Placement
Outlander Series
Advertisement
