Maintenance After Use; Lubrication - P.Lindberg Talex EcoCut 135 Original Manual

Maintenance after use

Always clean the mower after use. Wash the lower components (holders, blades,
counter blades) with a pressure washer and place the mower on a flat hard surface.
Inspect all joints. Worn or damaged parts must be replaced with new ones. Check all
bolted joints and tighten loose bolts and nuts (see table below).
Resistance
Thread
M5
M6
M8
M10
M12
M14
M16
M18
M20
M22
M24
It is also necessary to check the drive belts' tightness. If a belt is damaged, replace all
the belts with a set of new belts (always replace in sets). Adjust the whole set
according to the instructions in the previous section. Lubricate the mower as
instructed in the subsequent section. Keep all safety labels on the mower clean.

Lubrication:

All service and maintenance must be done with the engine switched off,
equalised pressure and stopped rotations, and both the tractor and
mower must be properly secured.
Avoid contact with pressurised oil!
Wear personal protective gear: protective clothing, safety shoes, glasses
and goggles.
Use and lubricate the telescopic PTO shaft as specified in the instructions.
P. Lindberg A/S
Tel.: +45 7021 2626
6.8 8.8
4.5 5.9
7.6 10
18 25
37 49
64 85
100 135
160 210
220 300
310 425
425 580
535 730
33
Sdr. Ringvej 1
DK-6600 Vejen
10.9
Torque (Nm)
8.7
15
36
72
125
200
310
430
610
820
1050
MAN 9054233_9054739_9058170 EN V3
12.9
10
18
43
84
145
235
365
500
710
960
1220
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk