Mounting On The Tractor - P.Lindberg Talex EcoCut 135 Original Manual

Mounting on the tractor

Make sure that the connecting parts on both the tractor and the mower
fit. In case of doubt, contact the supplier of either the mower or the
tractor.
The mower must be connected to the tractor by means of a three-point linkage. The
mower must be in the transport position while it is being connected to the tractor.
Connecting the mower to the tractor:
1. Set the mower in the tractor's bottom connection joint (first left, then right) and attach
them with bolts and cotter pins (1).
2. Attach the end of the top bar in the top-bar fitting's holes (2) with bolt and locking pin.
3. Lift the mower to remove the weight on the stabiliser.
4. Lift the stabiliser and insert and secure the cotter pin.
5. Connect the chain to the drawbar.
Adjust the telescopic PTO shaft according to its instructions.
P. Lindberg A/S
Tel.: +45 7021 2626
24
Sdr. Ringvej 1
DK-6600 Vejen
MAN 9054233_9054739_9058170 EN V3
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk