Assembly Instructions For Metal Shields - P.Lindberg Talex EcoCut 135 Original Manual

Assembly instructions for metal shields

Important! Loosely connect the bolts in steps 1–7 – do not fully tighten!
make the final tensioning of the components until the shields have been attached to
the frame and finally adjusted in step 11.
Step 1
• Find a solid, stable place for attaching the shields.
Lay out the right and left shields and U-profile sections.
•
Make sure that the holes (A) are correctly positioned (facing the same direction).
•
Step 2
• Attach the U-profile sections to the right and left shields as shown in the illustration
below.
The figure below shows which bolt components are used in steps 2–5.
P. Lindberg A/S
Tel.: +45 7021 2626
U-profile sections
Left shield
U-profile section
Sdr. Ringvej 1
DK-6600 Vejen
Right shield
15
MAN 9054233_9054739_9058170 EN V3
Do not
Detail A
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk