Set Lengths For Discrete 2 Of 5 - Motorola SE955 Integration Manual

8 - 52 SE955 Integration Guide

Set Lengths for Discrete 2 of 5

Parameter # L1 = 0x14, L2 = 0x15
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Lengths for D 2 of 5 may be set for any length, one or two discrete lengths, or
lengths within a specific range. To set lengths via serial commands, see
Commands on page
One Discrete Length - Select this option to decode only those codes containing a selected length. For
example, select D 2 of 5 One Discrete Length, then scan 1, 4, to decode only D 2 of 5 symbols containing 14
characters. Numeric bar codes begin on
scan Cancel on page
Two Discrete Lengths - Select this option to decode only those codes containing two selected lengths. For
example, select D 2 of 5 Two Discrete Lengths, then scan 0, 2, 1, 4, to decode only D 2 of 5 symbols
containing 2 or 14 characters. Numeric bar codes begin on
incorrect entry, scan
Length Within Range - Select this option to decode codes within a specified range. For example, to
decode D 2 of 5 symbols containing between 4 and 12 characters, first scan D 2 of 5 Length Within Range,
then scan 0, 4, 1 and 2 (single digit numbers must be preceded by a leading zero). Numeric bar codes begin
on page 8-75. To change the selection or cancel an incorrect entry, scan
Any Length - Scan this option to decode D 2 of 5 symbols containing any number of characters.
NOTE Selecting this option may lead to misdecodes for D 2 of 5 codes.
B-6.
page
8-76.
D 2 of 5 - One Discrete Length
Cancel on page 8-76.
D 2 of 5 - Two Discrete Lengths
D 2 of 5 - Length Within Range
D 2 of 5 - Any Length
Setting Code Lengths Via Serial
8-75. To change the selection or cancel an incorrect entry,
page 8-75. To change the selection or cancel an
Cancel on page 8-76.