Table of Contents
Advertisement
8 - 48 SE955 Integration Guide
Set Lengths for Interleaved 2 of 5
Parameter # L1 = 0x16, L2 = 0x17
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Lengths for I 2 of 5 may be set for any length, one or two discrete lengths, or lengths
within a specific range. To set lengths via serial commands, see Setting Code Lengths Via Serial Commands
on page B-8.
NOTE When setting lengths, single digit numbers must always be preceded by a leading zero.
One Discrete Length - Select this option to decode only those codes containing a selected length. For
example, select I 2 of 5 One Discrete Length, then scan 1, 4, to decode only I 2 of 5 symbols containing 14
characters. Numeric bar codes begin on
scan
Cancel on page
Two Discrete Lengths - Select this option to decode only those codes containing two selected lengths. For
example, select I 2 of 5 Two Discrete Lengths, then scan 0, 6, 1, 4, to decode only I 2 of 5 symbols
containing 6 or 14 characters. Numeric bar codes begin on
incorrect entry, scan
page
8-76.
I 2 of 5 - One Discrete Length
Cancel on page
8-76.
I 2 of 5 - Two Discrete Lengths
8-75. To change the selection or cancel an incorrect entry,
page
8-75. To change the selection or cancel an
Advertisement
Table of Contents
