Caulk/Sealant Application - Carrier Aero 39MN Series Installation, Start-Up And Service Instructions Manual

ROOFCAP
93M6X70500X000002 GASKET
TO BE ADDED BETWEEN THE
ROOFCAP AND BASERAIL ON
BOTH SIDES
Fig. 165 — Remove Lower Panel
4. Stack upper section for the supply air module on the return air
module making sure to align the stacked vertical frames.
Connect stacked base rail to frame as shown in Fig. 163.
5. Reinstall panel removed in Step 2 using the retained screws
over the roof cap flange.
6. Use caulk/sealant to seal gap at both sides starting at the bot-
tom of the panel and sealing 4 in. up.
7. Install the lower ERV wheel bypass section. Make standard
connections with hardware at baserail and intelliclamps (if
used).
PANEL
USE SEALANT PF20-78
(TEROSTAT) TO SEAL GAP
BETWEEN FRAME AND BOTTOM
4" OF PANEL (BOTH SIDES)
PANEL
ROOFCAP
Fig. 166 — Secure ERV Wheel on 3 in. Baserail
8. Stack the ERV wheel section and secure baserail to lower sec-
tion as shown in Fig. 163. Take care to vertically align the
faces of the stacked vertical frames.
9. Secure the ERV wheel section 3 in. baserail to the return air
module frame intelliclamp as shown in Fig. 166.
10. Secure the ERV wheel section frame intelliclamp to the sup-
ply air module 6 in. base rail as shown in Fig. 167.
11. Stack the upper ERV wheel bypass section and secure base-
rail to the lower section as shown in Fig. 163. Take care to
vertically align the faces of the stacked vertical frames.
12. Secure the upper ERV wheel bypass section 3 in. base rail to
the return air module frame intelliclamp as shown in Fig. 166.
13. Install lower level sections for the exhaust air module. Make
standard connections with hardware at baserail and intelli-
clamps (if used).
14. Secure the ERV wheel section 3 in. baserail to the exhaust air
module frame intelliclamp as shown in Fig. 166.
15. Secure the ERV wheel section frame intelliclamp to the
exhaust air module 6 in. baserail as shown in Fig. 167.
16. Stack the upper level sections for the outside air module on
the lower level exhaust air sections and secure baserail to the
lower section per Fig. 163.
17. Secure the ERV wheel section 3 in. baserail to the outside air
module frame intelliclamp as shown in Fig. 166.
18. Secure the ERV wheel section frame intelliclamp to the out-
side air module 6 in. baserail as shown in Fig. 167.
19. Make all remaining standard connections with hardware at
intelliclamps and top frame bracket.
20. Make all standard connections between roofcaps at splits of
upper level.
21. Make all standard connections to install slider on all con-
nected roofcaps.
22. Make all standard connections to install gasket and secure
bracket with screws at both ends of each roofcap connection.

CAULK/SEALANT APPLICATION

Apply caulk/sealant over the seam of every frame to frame
connection at unit splits as shown in Fig. 167 and 168.
193