Oma-Dm Commands - Multitech SocketModem Cell Device Manual

#915 FUMO – update fails with other reasons
#916 FUMO - Firmware Done, No firmware update
#919 FUMO - Firmware downloaded successfully
#920: FUMO - Firmware download progress (percent)
#921 FUMO - Firmware download start
#921 FUMO - Firmware size get from the OMA-DM server (byte)
#929: 200 FUMO - Firmware Update Success
#929: 402 FUMO - Firmware corrupted , CRC error
#929: 403 FUMO - Firmware Package Mismatch
#929: 404 FUMO - Firmware Signature Failed
#929: 406 FUMO - Firmware update Authentication Failed
#929: 410 FUMO - Firmware update General Error
#930 FUMO - Firmware Reporting Firmware Update result to server
#DREL FUMO - Firmware Data session release
Additional Network Initiated Alert Indications (NIA Retry)
#926 NIA - NIA retry start
#927 NIA - Notification Done with no NIFA information
#928 NIA - NIA digest mismatch error

OMA-DM COMMANDS

These commands are available after the unsolicited indication #900 appears, which means DM client is ready.
AT#OMADMSVADDR=<URL>
AT#OMADMSVADDR?
AT#OMADMSVPORT=<port#>
AT#OMADMSVPORT?
AT#OMADMPROXY=<port#>,<URL> Set OMA-DM proxy server port/URL (default
AT#OMADLPROXY=<port#>,<URL>
AT#OMADMCEN=<onoff>
AT#OMADMCEN?
AT#OMADMCEN=?
AT+OMADM=(onoff)
AT+OMADM=?
AT+PRL=<onoff>
AT+PRL=?
AT+FUMO=
SocketModem CDMA MTSMC-C2 Device Guide
Set OMA-DM server address (default https://oma.ssprov.sprint.com/oma)
Read OMA-DM server address
Set OMA-DM server (default 443)
Read OMA-DM server
http://oma.ssprov.sprint.com:80)
Set OMA-DL Proxy DL Server Port URL (default
http://oma.ssprov.sprint.com:80)
Set OMA-DM Client feature; Disable=0, Enable=1
Important:
Never deploy devices with AT#OMADMCEN=0. Many OMA
commands result in error if OMADMCEN is set to 0.
Query the current OMA-DM client status
Query OMA-DM available values
Set OMA-DM Client Initiated Device Configuration; Disable=0, Enable=1,
Initiate=2
Query OMA-DM Client Initiated Device setting
Set OMA-DM CIPRL Session; Disable=0, Enable=1, Initiate=2
Query OMA-DM CIPRL Session setting
Set OMA-DM FUMO enable parameter; Disable=0, Enable=1, Initiate=2
CHAPTER 6 –APPLICATION NOTES
16