Device Phone Number; Adding Apn Value; Sprint Activation And Oma-Dm Commands (Lsp3) - Multitech MultiConnect MicroCell MTCM-LAT3 User Manual

ANTENNA AND ACTIVATION INFORMATION

Device Phone Number

Every device has a unique phone number. Your service provider supplies a phone number when you activate your
account, or if your device has a SIM card, the phone number may be on it. Wireless service provider
implementation may vary. Consult with your service provider to get the phone number for your device.

Adding APN value

After properly setting up your account with your carrier and activating and installing your SIM card, you need to
add your carrier's APN (Access Point Name) into the device before the cellular modem is ready for use.
To add your APN value:
1. Establish a terminal session with the device.
2. Enter the command:
AT+CGDCONT=1,"IP","APN_Name"
(where APN_Name is the APN provided by your wireless carrier).

Sprint Activation and OMA-DM Commands (LSP3)

All applications interacting with Sprint approved MultiTech devices must be written in a manner where they do not
interfere/interrupt the Sprint Hands-Free Activation (HFA) process or OMA-DM processes.
If the MultiTech device will be co-located with any other transmitters you will be required to submit your device to
an FCC approved lab for additional testing.
If the Sprint approved MultiTech device/circuit board is embedded into another device/circuit board be aware you
must perform EMC and safety testing on your end device
These commands are available after the unsolicited indication #900 appears, which means DM client is ready. For
more details, refer to the appropriate Telit AT Command guide on the product page at www.multitech.com.
AT+GMM
AT+GMR
AT+OMADM=<on/off>
AT+OMADM?
AT+PRL=<on/off>
AT+PRL?
AT#HFA
AT+HFA?
AT$RTN=xxxxxx
AT+OMAPOLL=<on/off>
AT#SPRPL=<value>
18
Your wireless carrier assigns the APN. If you don't know the APN, contact your wireless carrier.
Returns cellular radio hardware model
Return cellular radio firmware version
Set OMA-DM Client Initiated Device Configuration: Disable=0, Enable=1,
Initiate=2
Query OMA-DM Client Initiated Device setting
Set OMA-DM CIPRL Session; Disable=0, Enable=1, Initiate=2
Query OMA-DM CIPRL Session setting
Initiate Sprint Hands Free Activation (HFA)
Query current OMA-DM HFA setting
HFA reset (after device reboot HFA will occur) xxxxxx= SPC or MSL.
Set OMA-DM Client Polling: Disable=0, Enable=1
Set device polling interval before DC+PRL session in hours - default = 720
hours (30 days)
Note: May not work with all firmware versions.
®
MultiConnect MicroCell MTCM-LAT3 and -LSP3 User Guide