Canon iR1200 Series Service Manual page 81

#SSSW-SW02:
Bit Function
0 start-up at memory clear list out-
put fault
1 not used
2 not used
3 not used
4 not used
5 not used
6 not used
7 not used
[Bit 0]
Use it to specify whether or not to put the machine in standby state if the memory clear
list is not generated when the power is turned on after an error has occurred (e.g., running
out of paper).
If set to '1', the machine will generate a memory clear list and enters standby state when
the image data is cleared and the power is turned on.
If set to '1', moreover, the following takes place:
1. The alarm sounds, and the machine waits for correction; specifically,
a. The LCD indicates 'CHECK PRINTER'.
b. The machine will not start reception operation in response to arrival of data.
2. When an appropriate correction is made, the machine will automatically generate a
memory clear list. If an error (e.g., jam) occurs during output, the machine goes back to
1. above.
If set to '0', on the other hand, the machine will sound the alarm and enters standby state.
COPYRIGHT © 2002 CANON INC.
network connection conditions setting
2000 2000 2000 2000
CHAPTER 2 USING THE MACHINE
1 0
prohibit do not prohibit
-
-
-
-
-
-
-
-
-
-
-
-
-
-
CANON iR1200/iR1300 Series REV. 0 AUG. 2002
Factory setting
0
2-33