Henny Penny 500 Operator's Manual page 72

data plate
deadweight
deadweight valve assembly
deadweight cap
deadweight orifice
deadweight body
dilution box
(gas fryers only)
drain interlock switch
drain valve
drop temperature
dumping table
exhaust hose
fill lines
filter clips
filter union
filter drain pan
filter envelope
filter quick disconnect
filter screen assembly
flame sensors
(gas fryers only)
G-2
a label or plate located on the right side panel of the fryer that indicates the fryer type,
serial number, warranty date, and other information
a metal cylinder that works with the orifice to regulate the amount of steam entering the
deadweight assembly
an assembly that controls pressure inside the frypot; the entire deadweight assembly
should be cleaned according to the recommended procedures; the assembly is made up of
the deadweight, the deadweight cap, the deadweight orifice, the deadweight valve, and
the deadweight body
a threaded cap that screws onto the deadweight valve housing
an opening that regulates the amount of steam entering the deadweight assembly
a container that holds the deadweight assembly
a metal air intake device on the rear of eight head fryers which allows the blower
to pull in fresh air
a microswitch that automatically shuts off the fryer heat in the event the drain valve is
inadvertently opened while the fryer power switch is in the ON position
a valve that allows the shortening to drain from the frypot into the filter drain pan; the
fryer power switch should be in the OFF position before the drain valve is opened; the
drain valve should remain closed at all other times
the starting, preset cooking temperature, at which product is placed in the shortening
a table onto which the cooked product is dumped after removal from the frypot
a hose used to vent steam from the frypot on eight head fryers
the lines marked on the interior rear wall of the frypot that show the proper shortening
level (also referred to as level indictor lines)
the clips are the part of the filter screen assembly that holds the filter envelope closed
the threaded connection between the fryer and the filter system that can be connected or
released without tools
a pan that rolls or slides under the fryer into which shortening is drained
a fiber envelope into which the filter screen is placed; the end of the envelope is folded
and held closed with filter clips; a part of the filter screen assembly
an optional connection on the fryers allowing the filter rinse hose to be connected or
released without tools
an assembly that filters the shortening as it is pumped from the frypot; the assembly is
made up of two filter screens, a filter envelope, and two filter clips (Note: four head fryers
have three filter screens that include a crumb catcher)
the sensors that shut off the gas supply to eight head gas fryers if the pilot light goes out
or does not light
Model 500/561/600
203