Henny Penny 500 Operator's Manual page 31

3-1. OPERATING COMPONENTS
(Continued)
Item Description
18 Safety Relief Valve Ring
19 Pressure Gauge
20 Solenoid Valve
21 Drain Valve (Only the
Handle is Shown)
22 Drain Interlock Switch
23 Filter Drain Pan
703
Function
DO NOT PULL THIS RING. SEVERE BURNS FROM
THE STEAM WILL RESULT.
Indicates the pressure inside the frypot
An electromechanical device that causes pressure to be held in the
frypot; the solenoid valve closes at the beginning of the Cook Cycle
and is opened automatically by the timer at the end of the Cook
Cycle; if this valve becomes dirty or the teflon seat nicked, pressure
will not build up and it must be repaired
A two-way ball valve that is normally close; turn the handle to drain
the shortening from the frypot, into the filter drain pan
DO NOT OPEN THE DRAIN VALVE WHILE FRYPOT
IS UNDER PRESSURE. HOT SHORTENING WILL
EXHAUST AND SEVERE BURNS WILL RESULT.
A microswitch that provides protection for the frypot in the event an
operator inadvertently drains the shortening from the frypot while
the main power switch is on; the switch automatically shuts off the
heat when the drain valve is opened
The removable pan that houses the filter and catches the shortening
when it is drained from the frypot; it is also used to remove and
discard old shortening
When moving filter drain pan containing hot shortening,
use extreme care to avoid burns from hot surfaces or
splashing.
Model 500/561/600
3-3