Table of Contents
Advertisement
Available languages
Available languages
T
ABLE OF
Incubating Microplate Shaker . . . . . . . . . . . .
1
C
ONTENTS
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . . 9-10
. . . . . . . . . . . .
. . . . . . . . . . . . 12-13
. . . . . . . . . . . .
P
C
ACKAGE
ONTENTS
1
Incubating Mini Shaker or Incubating Microplate Shaker
234cm detachable power cord
1
Instruction manual
2
2
I
NSTALLATION
2
Upon receiving the VWR Incubating Mini/Microplate Shaker, check to
2
ensure that no damage has occurred during shipment. It is important
that any damage that occurred in transport is detected at the time
3
of unpacking. If you do find such damage the carrier must be notified
3
immediately.
4
After unpacking, place the Incubating Mini/Microplate Shaker on a
5-6
level bench or table, away from explosive vapors. Secure to an
7-8
immovable work surface by pressing down on the four (4) corners of
the unit, creating a strong suction to the work surface (DO NOT place
on a bench mat). Ensure that the surface on which the unit is placed
11
will withstand typical heat produced by the unit. Always place the
unit on a sturdy work surface.
14
The Incubating Mini/Microplate Shaker is supplied with a power cord
that is inserted into the IEC connector on the back of the unit first,
then it can be plugged into a properly grounded outlet. The 230V
unit plugs into a 230 volt, 50/60 Hz source.
Hide quick links:
Advertisement
Chapters
Table of Contents
