Table of Contents
Advertisement
CITY SERIES
installation
11. Loosen 4 screws in locations shown below (2 at front and 2 at rear)—slide
burner to the left away from the orifice and lift out.
front
screw locations
12. Remove burner orifice with a 9.5mm spanner. Use another wrench to hold
on to the elbow behind the orifice. Discard orifice. Reinstall new burner
orifice LP stamped #53 (or #54 ULPG) and tighten.
CV40E shown
13. Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifice.
Pilot retainer clip
Installer Notice:
These instructions must be left
with the appliance
920-217
| ACV40E City Series
56
back screw locations
Burner Orifice
Location
.
14. Unscrew the pilot orifice with the allen key; then replace with the LPG
pilot orifice and the pilot cap, provided in the kit.
15. Reinstall pilot cap and pilot retainer clip.
16. Prior to installing burner—adjust aerations settings:
• 7 mm for Propane
• Fully open for ULPG
Reinstall burner (see Step 13).
17. Ensure the pilot light is in the correct orientation to the Burner. Recon-
nect the gas and electrical supply to the appliance. Start the appliance.
(see section on Lighting Instructions) Ensure that pilot and burner igni-
tion is completed without delay. Check both your inlet and outlet pres-
sures at full load. With a soapy solution, leak test the entire system.
Verify both the correct flame and pilot appearance.
18. See Gas Pipe Pressure Testing in manual.
PROPANE SYSTEM DATA
Min. Supply Pressure
Manifold Pressure High
Manifold Pressure Low
Orifice Size
Maximum Input
Minimum Input
ULPG SYSTEM DATA
Min. Supply Pressure
Manifold Pressure High
Manifold Pressure Low
Orifice Size
Maximum Input
Minimum Input
2
2.75 kPa
2.60 kPa
0.70 kPa
#53 DMS
30 MJ/h
16.0 MJ/h
2.75 kPa
2.60 kPa
0.63 kPa
#54 DMS
24 MJ/h
11.7 MJ/h
03.12.20
Advertisement
Table of Contents
