Installation Checklist - Regency City ACV40E Series Owners & Installation Manual

Installation Checklist

1. Locate appliance. Refer to the following sections:
a) Locating Your Fireplace
b) Clearances
c) Combustible Mantel Clearances
d) Framing & Finishing
e) Flueing. See the "Flueing Introduction" to
"Flueing Arrangements" sections.
2. A ssemble Standoffs. Refer to the "Unit Assem-
bly Prior to Installation" section. (NOTE: must
be done before installing unit into fireplace.)
3. I nstall vent. See the "Horizontal Installations"
to "Installation Procedures" sections.
4. Install 4AA batteries into receiver battery
box. Hook receiver to wiring marked receiver,
this will enable operation of the appliance
manually when position in "ON" position.
Note: The wire harness (marked receiver) is
located near the gas valve and will need to be
routed to the exterior of the fireplace from either
the left or right hand side of the appliance prior
finishing.
5. Bring 240 volt power to appliance. Required
to operate lights and highly recommended to
operate gas valve. AA Batteries serve as back
up only if 240 volt power is lost.
6. Make gas connections. T est the pilot. Must be as
per diagram. Refer to the "Gas Line Installation"
& "Pilot Adjustment" sections.
7. Install standard and optional features. Refer
to the following sections where applicable:
a. Safety Glass
b. Firebox (inner) glass
c. Log Set
d. Fireglass
e. Ceramic stones or other approved media
f. P ainted or enamel (panels required)
g. Optional Framing Kit
h. Heatwave Kit
8. Final check.
Before leaving this unit with the customer, the
installer must ensure that the appliance is firing
correctly and operation fully explained to customer.
This includes:
1. Clocking the appliance to ensure the correct
firing rate (rate noted on label 30Mj/h NG/LP)
after burning appliance for 15 minutes.
2. If required, adjusting the primary air to ensure
that the flame does not carbon. First allow the
unit to burn for 15-20 min. to stabilize.
CAUTION: Any alteration to the product that causes
sooting or carboning that results in damage
is not the responsibility of the manufacturer.
installer's information
ACV40E City Series | 19