Nokia FastMile Installation Manual page 91

Nokia FastMile 4G Receiver Installation Guide
Procedure 9
1
2
3
4
Issue: 02 DRAFT
To mount and connect the Nokia FastMile 4G Receiver
Confirm that the location identified in chapter
home, and that Ethernet cabling can be safely and securely run from the mounting location
though the wall, and inside the home to the residential gateway or PoE injector, or to the
prospective residential gateway or PoE injector location. The PoE injector must be a
Nokia-approved PoE injector, and Nokia advises that it should be grounded and put as close
as possible to the place where the Ethernet cable enters the home.
Make sure that you have the following from the shipping package as appropriate:
•
Nokia FastMile 4G Receiver
•
bracket kit consisting of:
•
mounting plate
•
receiver bracket: note that the receiver bracket is shipped attached to the mounting plate
with three fasteners
•
two fasteners for attaching the mounting plate to the Nokia FastMile 4G Receiver
•
pole adapter
Separate the mounting plate from the receiver bracket and save the three fasteners for
securing the mounting plate to the receiver bracket later on in this procedure.
Use the two supplied screws to attach the mounting plate to the back of the Nokia FastMile
4G Receiver as shown in Figure 46. Be sure to orient the mounting plate as shown in the
figure.
3TG-00387-AADA-TCZZA
Mounting and connecting the Nokia FastMile 4G
10 is suitable for considerations within the
Receiver
67