Lightning Protection - Nokia FastMile Installation Manual

Nokia FastMile 4G Receiver Installation Guide
•
•
•
•
•
•
•
•
8.2.1
Be sure to observe the following lightning protection information:
Issue: 02 DRAFT
If the outside Ethernet cabling will be longer than 20 meters (64 feet), you will
need a PoE+ capable surge protector for lightning protection, subject to local
regulations, as indicated in section
A ground cable might be needed to connect the Nokia FastMile 4G Receiver to an
outdoor ground; see section
connection of a ground cable requires a hex key suitable for hex socket knurled
head cup screw assemblies, ISO 4762-M5X8
Appropriate fastening means are needed for securing the Nokia FastMile 4G
Receiver to an outside wall or to a pole, such as strapping
Silicone or other waterproof sealing or caulking compound
Mechanical tools are required (but are not included) for mounting the Nokia
FastMile 4G Receiver, including:
•
TORX T8 screwdriver to open the SIM slot
•
hex key as described above to connect a ground cable to the Nokia FastMile 4G
Receiver
The Nokia Wireless app must be installed on an Android mobile phone through
Google Play and the mobile phone must have a Bluetooth adapter, camera,
hardware compass, rotation vector (either a gyroscope or an enhanced
geomagnetic sensor that supports rotation vector), and Android OS 6.0
(Marshmallow) or above; see the Nokia FastMile 4G Receiver Customer Release
Notes for information about accessing the Nokia Wireless app and installing it
The LTE base station that will be used by the Nokia FastMile 4G Receiver must
be available and functioning
The residential gateway that will be connecting to the Nokia FastMile 4G Receiver
must be available and reachable; if the residential gateway cannot supply PoE
power to the Nokia FastMile 4G Receiver, then a Nokia-approved PoE injector
must be used in conjunction with the residential gateway. Nokia advises that the
PoE injector should be grounded and put as close as possible to the place where
the Ethernet cable enters the home.

Lightning protection

If you are installing the Nokia FastMile 4G Receiver
Danger —
above roof level, check that lightning rods are above the
planned installation location.
PoE+ capable surge protectors should be used between the
Nokia FastMile 4G Receiver and the residential gateway or
PoE+ injector if the outside Ethernet cabling is longer than 20
meters (64 feet), subject to local regulations. If the outside
Ethernet cable length is less than 20 meters (64 feet), no
protection is required, subject to local regulations.
A properly earthed wall socket should be used for the
residential gateway or PoE+ injector that is used to power the
Nokia FastMile 4G Receiver.
3TG-00387-AADA-TCZZA
Reviewing roles and installation prerequisites
8.2.1
8.2.1 for lightning protection and ground information;
19