Inserting the SIM card in the Nokia FastMile 4G
Receiver
3
9.3 Extracting the SIM card
Although the following procedure provides instructions for extracting a SIM card from
the Nokia FastMile 4G Receiver, you should contact your Nokia representative for
more detailed information.
Procedure 6
1
2
3
24
For the Compact multi-band models:
•
turn the Nokia FastMile 4G Receiver bottom up
•
put the SIM card into the tray in the correct orientation
•
use your fingers to hold and push the tray and card all the way into the slot, with the hole
on the right
You need to insert the SIM card deep in the slot until the slot locks the SIM card in place.
Re-attach the cover on the SIM card slot after you have inserted the SIM card.
To avoid the possibility of a short circuit, make sure
Warning —
that the Nokia FastMile 4G Receiver is in a powered off state
before extracting the SIM card.
To extract the SIM card from the Nokia FastMile 4G Receiver
Use a TORX T8 screwdriver to remove the cover from the SIM card slot of the Nokia FastMile
4G Receiver.
Extract the SIM card:
For the Compact mono-band and ABA models, use a small plastic blunt tool to carefully push
the SIM card, and then to carefully pick the SIM card out from the slot.
For the Compact multi-band models, push a needle-like tool into the hole to eject the tray,
and then use your fingers to pick the tray out and get the SIM card.
Re-attach the cover on the SIM card slot if you are not installing a new SIM card.
3TG-00387-AADA-TCZZA
Nokia FastMile 4G Receiver Installation Guide
Issue: 02 DRAFT