Height And Tension Adjustment Of Presser Foot; Adjustment Of Automatic Knee-Lifter - Garudan GF-105 Series User Manual

10. Height and Tension Adjustment of Presser Foot

A. Aa is Fig.19, remove the rubber plug
(2) in the face plate and place the
presser foot (3) on the needle plate.
Then, loosen the presser bar fixing
screw (4) and adjust the height of
the presser bar. The presser foot
lifter (3) will fall when the presser
bar is lifted and rise when the
presser bar is moved down. Move
the presser foot lifter (5) manually to
place the bottom face of the presser
foot 5,5 mm above the top face of
the needle plate and tighten the
presser bar fixing screws firmly.
B. The tension of the presser foot will
grow stronger when the tension
adjusting screw
clockwise and turned clockwise and
weaker when turned counterclockwise. Make sure to screw in the fixing nut (1) after adjustment.
(Fig.19)
C. Loosen set screw (1) and adjust the presser bar height or the angle of the presser foot. After
adjustment, securely tighten the setscrew.

11. Adjustment of Automatic Knee-Lifter

An automatic knee-lifter will be attached to the sewing machine at point of delivery. The lifting amount
of the presser foot when automatically lifting the knee is controlled by the automatic knee-lifting
solenoid shaft crank (1). First, loosen the solenoid cover fixing screw (3) and remove the solenoid
cover (2). If the solenoid shaft (5) is moved left and the fixing screw (4) is tightened when the solenoid
crank shaft fixing screw (4) is loose, the amount of the presser foot grows smaller. If the solenoid shaft
(5) is moved to the right, the lifting amount will grow bigger. Assemble the cover back after the
adjustment is completed. (the presser foot lifting amount for the automatic knee-lifter will be set to 13
mm by default at point of delivery).
Serie GF-105
(6) is turned
Fig
. 19a
Fig.20
ANITA ©
Fig. 19
14