Adjusting The Needle Stop Position; Inserting Lower Thread And Tension Adjustment - Garudan GF-105 Series User Manual

ANITA ©

6. Adjusting the Needle Stop position

7. Inserting Lower Thread and Tension Adjustment

A. After placing a bobbin (2) in a bobbin case (6), push the thread through the thread groove (3) and
hook it under the tension adjusting plate spring (4). To tighten the lower thread, turn the tension
adjusting screw (5) clockwise.Turn it counterclockwise to loosen. Adjust the tension of the lower
thread so that it will fall slowly by gravity when the bobbin case (1) is dropped while holding the
end of the thread.
B. Hold the bobbin case handle (6) and insert it into hook. Pull the handle (6) to remove. (The bobbin
will fall out if the handle is let go). (Fig.14)
Serie GF-105
Obr. 13
Fig.14
11