Warranty; Intended Use; Safety Instructions - Kärcher WRS 200 Manual

Licence plate
A licence plate (repeater licence plate) must be attached before
use on public roads.
A damaged blade guard must not be used
Licence plate position
1

Warranty

The warranty conditions issued by our relevant sales company
apply in all countries. We shall remedy possible malfunctions on
your appliance within the warranty period free of cost, provided
that a material or manufacturing defect is the cause. In a warranty
case, please contact your dealer (with the purchase receipt) or
the next authorised customer service site.
(See overleaf for the address)

Intended use

These operating instructions describe the handling of the WRS
200 attachment kit.
The attachment kit can be attached to the following vehicles us-
ing the corresponding adapter.
 MIC 35/42
 MIC 50/70
 MC 130
The WRS 200 attachment kit is intended for the outdoor elimina-
tion of weeds using a hot water high-pressure cleaner and asso-
ciated weeding tools.
The high-pressure cleaner can also be used for cleaning loca-
tions that are difficult to access.
The device may only be connected to the public water supply via
a suitable backflow preventer.
The WRS 200 attachment kit may only be used for the intended
use, as illustrated and described in these operating instructions.
Intended use also includes adherence to the prescribed mainte-
nance activities and intervals.
The vehicle and attachments may only be used, maintained and
repaired by persons familiar with the vehicle and attachments
and the associated hazards.
The legally applicable general safety and accident prevention
regulations must be adhered to. All other safety regulations, oc-
cupational health care regulations and road traffic regulations
must be adhered to.
The operating personnel must:
 Be physically and mentally suitable
 Have been instructed in the handling of the vehicle and attach-
ments
 Have read and understood these operating instructions and
the operating instructions for the vehicle to which this attach-
ment kit is attached
 Have provided the operating company with verification of ca-
pability to operate the vehicle
 Be explicitly nominated to operate the vehicle by the operating
company
The following safety instructions apply to the device:
 Observe the respectively applicable national regulations for
liquid jet cleaners.
 Observe the respectively applicable national accident preven-
tion regulations. Liquid jet cleaners must be inspected regular-
ly and the results of the inspection recorded in writing.
 Note that the heating system in the device is classified as a fur-
nace. Furnaces must be inspected regularly according to the
applicable national regulations.
 According to the application national regulations, this device
must be initially commissioned by a qualified person when
used commercially. KÄRCHER has already performed and
documented this initial commissioning for you. You can re-
quest the documentation for this from your KÄRCHER partner.
Please provide the part number and works number of the de-
vice when requesting documentation.
 We explicitly state that the application national regulations re-
quire that this device must be inspected regularly by a quali-
fied person. Please contact your KÄRCHER partner for this.
 No modifications may be made to the device or accessories.
ATTENTION
Information on safety, charging, care and disposal of the battery
is provided in the vehicle operating instructions.
Always cover the plus terminal of the battery with the protective
cap.
The following safety instructions apply to the high-pressure hose:
 Use only original high-pressure hoses.
 The high-pressure hose and the spray unit must be suitable for
use at the maximum operating pressure specified in the tech-
nical data.
 Avoid contact with aggressive chemicals.
 Inspect the high-pressure hose daily.
Do not continue using kinked hoses. Do not continue using the
high-pressure hose if the outer wire mesh layer is visible.
 Do not continue using a high-pressure hose with a damaged
thread.
 Lay the high-pressure hose so that it cannot be driven over or
presents a tripping hazard to persons.
 A hose that has been driven over, kinked or subjected to im-
pacts may no longer be used, even if no damage is visible.
 Store the high-pressure hose in a manner avoiding mechani-
cal stresses on the hose.
Note
Replace the symbols immediately if they become illegible or get
lost.
DANGER
Risk of burns from hot surfaces
Allow the vehicle to cool down before working on it.
WARNING
Risk of injury from high-pressure jet
Do not direct the high-pressure jet at persons, ani-
mals, live electrical equipment or at the device itself.
Protect the device high-pressure cleaner frost.
Warning of rotating tools
Dangerous electrical voltage!
Do not place any foreign objects or tools on the bat-
tery.
English

Safety instructions

Battery
High-pressure hose
Symbols on the device
17