Storage; Care And Maintenance; Maintenance Intervals - Kärcher WRS 200 Manual

Working with the WRS 200
WARNING
Risk of injury due to recoil force
A recoil force will arise due to the water stream ejecting from the
spray lance. Make sure you grip the high-pressure gun and spray
lance firmly when working.
Safety latch
1
Trigger
2
Pressure control
3
1. Unlock the safety latch on the high-pressure gun, rear posi-
tion.
2. Pull the trigger and commence working.
3. Fight weeds with the hot water jet, working slowly
4. As necessary: Adjust the pressure control at the spray lance
or at the high-pressure cleaner as required.
high-pressure gun and spray lance storage
Store the trigger gun with spray lance and high-pressure hose in
the storage locations provided when driving on public roads or af-
ter finishing work.
Finishing work
1. Park the vehicle and allow the engine to continue running.
2. Set the temperature control to 0 °C and switch off the burner
blower.
3. Operate the high-pressure cleaner in cold water mode until the
high-pressure cleaner, high-pressure hose and high-pressure
gun with spray lance have cooled down (danger of burns).
4. Switch off the PTO work hydraulics.
5. Switch off the engine.
6. Close off the water inlet at the water tank.
7. Press the trigger of the trigger gun and release the pressure
remaining in the system.
8. Secure the trigger with the safety latch.
Lock
1
9. Unscrew the high-pressure hose from the high-pressure con-
nection of the WRS 200. Fit a protective cap to prevent soiling.
26
Storing the high-pressure hose
1
High-pressure gun with spray lance
2
Holder with rubber latch
3
Mounting
4
10.Fit the high-pressure gun with spray lance into the mount and
holder and secure with the rubber retainer.
11.Open the right-hand door and place the high-pressure hose in
the storage compartment.
CAUTION
Risk of injury and damage
Be aware of the weight of the device during storage.

Care and maintenance

Maintenance intervals

Note
In order to preserve warranty claims, all servicing and mainte-
nance work during the warranty period has to be performed by an
authorised Kärcher Customer Service, in accordance with the in-
spection check list.
Time & date Activity
Daily Check the oil level in the high-
pressure pump, refill with oil if
necessary
Daily General visual inspection of
the WRS 200
Daily Check the water filter, clean if
necessary
Daily Check the filling level in the
system care container and fill
with RM 110 if necessary
After the first 50 Replace the oil in the high-
operating hours pressure pump
Every 50 operat- Check the battery, see the in-
ing hours or formation on the battery
weekly
Every 600 oper- Replace the oil in the high-
ating hours or pressure pump
annually
English

Storage

By whom
Operator
Operator
Operator
Operator
Customer Ser-
vice
Operator
Customer Ser-
vice