Table of Contents
Advertisement
–
Removing the
COMBICON
connectors
– Remove base
GFK-2734
The module can be removed without removing the COMBICON connectors.
•
Pull the COMBICON connectors from the module. Hold onto the COMBICON
connector housing when removing it. Do not pull on the cables to remove the
COMBICON connector.
•
Release the base by pressing on the front and back snap-on mechanisms (A) and pull
it out perpendicular to the DIN rail (B).
A
B
A
Figure 4-5
Removing the safety module base
4.2
Electrical installation
WARNING: Electric shock/unintentional machine startup
Prior to electrical installation, disconnect the power to the system and make sure that it
cannot be switched on again unintentionally.
Make sure installation has been completed before switching the power back on.
The system may only be started provided the system does not pose a hazard.
4.2.1
Electrical installation of the VersaPoint station
Electrical installation of the VersaPoint station includes the following:
–
Connecting PROFIBUS or PROFINET to the VersaPoint station
–
Connecting the supply voltages for the VersaPoint station
Carry out electrical installation for the VersaPoint station according to the GFK-2736 user
manual or the VersaPoint system manual for your bus system. Please also observe the
specifications in the documentation for the bus coupler used.
Chapter 4 Assembly, removal, and electrical installation
4
4-5
Advertisement
Table of Contents
