4
–
Insert connectors
–
Inserting the
VersaPoint
connectors
–
Inserting the
COMBICON
connectors
Removal
–
Removing the
VersaPoint
connectors
4-4
1 A
1 B
Figure 4-2
Snapping on the safety module base
•
Check that all the snap-on mechanisms are securely snapped into place.
Only use the connectors supplied with the module or connectors that are approved as
replacement items (see "Ordering data: Accessories" on page 11-9).
•
Insert the connectors in the specified order (A, B).
A
Figure 4-3
Inserting the connector
•
Insert the connectors.
•
Disconnect the power to the station.
•
Before snapping on the safety module, remove the connectors from the safety module
and the adjacent connector from the neighboring VersaPoint terminal on the left.
•
Remove the connectors by pressing the back shaft latching (A) and levering off the
connector (B).
A
B
Figure 4-4
Removing the connector
User manual IC220SDL840 - May 2018
B
GFK-2734