Web Enabled Control - Hayward TriStar VS 900 Omni Operation Manual

Vs omni series pool automation control

Hide thumbs Also See for TriStar VS 900 Omni:

Owner's manual (20 pages)

Table Of Contents

Table of Contents

The VS Omni should have already been configured for use with the home's router to allow for

remote control through the web. This procedure is covered in the Configuration Wizard information

found in the Installation manual. After configuration, an account must be created to allow access

to the VS Omni from web enabled devices. If this has not already been done by the installer, follow

the procedure below.

Using an ordinary web browser, go to www.haywardomnilogic.com. If you don't already have

an account, select "Register New User" and set up a new account.

your VS Omni. When asked for your Time Zone, be sure to enter the same time zone as the

physical location of the installed VS Omni, otherwise schedules will be inaccurate. You'll also

be asked for an MSP System ID. This number can be found directly from the VS Omni. To

find your unit's MSP ID, follow the procedure below.

MSP ID

71º F

air

After the MSP is accepted, the VS Omni will be linked to your account. You'll be able to access the

VS Omni at any time from your browser by logging into your account at haywardomnilogic.com.

For mobile devices, download the "OmniLogic" app from your device's app store. Login to your

account through the app and you should see the VS Omni.

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS