Maintenance - Valor Portrait Ledge 569 Series Installation Manual

11. Slide the mounting frame over the appliance case.
The front of the frame has 4 screws protruding
from it. Fix the frame to the stud mounting panels
on each side of the appliance (3 screws per side).
12. Apply wall finish on top of drywall.
IMPORTANT: The drywall is assumed to be 1/2 inch
thick.
Wall finish material thickness on top of drywall
such as tile, brick, and so on:
When finishing under optional 570 Plate:
1/2 inch maximum.
When finishing around optional 570 Plate:
see mantel clearances if finish protrudes from plate.
Without 570 Plate: 1-1/8 inch maximum.
13. Hook the window trim cover on the top edge of the
window frame.
Top
Window frame cover—
rear view
14. Hook the front trim to the mounting frame placing
its keyholes on the protruding screws on the front
face of the mounting trim and slide it downward to
fit it.

Maintenance

WARNING
DO NOT TOUCH THE BARRIER SCREEN,
CAST FRONT OR GLASS WHILE THEY ARE
HOT! Let the fireplace cool first before
performing any maintenance.
WARNING
FOR YOUR SAFETY, ensure the barrier
screen in installed on the fireplace after
maintenance.
To clean the front trim, use mild soap and water. You
can dust the screen with a soft brush. To brush the back
of the screen, simply unhook the front trim.
If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer's barrier for this
appliance.
To clean the window and ceramics inside the firebox,
consult the Owner's Information section of the Installation
and Owner's Manual supplied with the fireplace.
DO NOT CLEAN THE GLASS WINDOW WITH AMMONIA!
9