Safety - LEGRAND Inform SINUS EVO User Manual

2. SAFETY

Information related to safety of the UPS, battery, load and the user is summarized below. But the
equipment should not be installed before reading the manual completely.
•
This UPS utilizes voltage that may be hazardous. Do not attempt to disassemble the unit. The unit contains no
user replaceable parts. Only factory service personnel may perform repairs.
•
The mains socket outlet that supplies the UPS shall be installed near the UPS and shall be easily accessible.
•
During the installation of this equipment it should be assured that the sum of the leakage currents of the UPS
and the connected loads does not exceed 3.5mA.
•
Place cables in such a way that no one can step on or trip over them.
•
Do not connect domestic appliances such as hair dryers to UPS output sockets.
•
The UPS can be operated by any individuals with no previous experience.
•
Connect the UPS system only to an earthed shockproof outlet which must be easily accessible and close to the
UPS system.
•
Please use only VDE-tested, CE-marked mains cable (e.g. the mains cable of your computer) to connect the
UPS system to the building wiring outlet (shockproof outlet).
•
Please use only VDE-tested, CE-marked power cables to connect the loads to the UPS system.
•
Connection to any other type of receptacle other than a two-pole, three-wire grounded receptacle may result
in shock hazard as well as violate local electrical codes.
•
In the event of an emergency, press the "OFF" button and disconnect the power cord from the AC power
supply to properly disable the UPS.
•
Do not disconnect the mains cable on the UPS system or the building wiring outlet (shockproof socket outlet)
during operations since this would cancel the protective earthing of the UPS system and of all connected loads.
•
The UPS system features its own, internal current source (batteries). The UPS output sockets or output
terminals block may be electrically live even if the UPS system is not connected to the building wiring outlet.
•
In order to fully disconnect the UPS system, first press the OFF/Enter button to disconnect the mains.
•
Prevent no fluids or other foreign objects from inside of the UPS system.
•
Do not allow any liquids or any foreign object to enter the UPS. Do not place beverages or any other liquid-
containing vessels on or near the unit.
•
This unit intended for installation in a controlled environment (temperature controlled, indoor area free of
conductive contaminants). Avoid installing the UPS in locations where there is standing or running water, or
excessive humidity.
•
Do not plug the UPS input into its own output.
•
Do not attach a power strip or surge suppressor to the UPS.
•
Do not attach non-computer-related items, such as medical equipment, life-support equipment, microwave
ovens, or vacuum cleaners to UPS.
•
Do not dispose of batteries in a fire as they may explode.
•
Attention, hazardous through electric shock. Also with dis- connection of this unit from the mains, hazardous
voltage still may be accessible through supply from battery. The battery supply should be therefore
disconnected in the plus and minus pole at the connectors of the battery when maintenance or service work
inside the UPS is necessary.
•
To reduce the risk of overheating the UPS, do not cover the UPS' cooling vents and avoid exposing the unit to
direct sunlight or installing the unit near heat emitting appliances such as space heater or furnaces.
•
Unplug the UPS prior to cleaning and do not use liquid or spray detergent.
•
Please replace the fuse only with the same type and amperage in order to avoid fire hazards.
•
WARNING: This is a category C2 UPS product. In a residential environment, this product may cause radio
interference, in which case the user many be required to take additional measures. (only for 220/230/240 VAC
system)
6