Fig. 4-81 Pickup Roller Spacing - Canon NP-70 Service Manual

NP -70
4-69
3)
CONTROLLER SPACING ADJUSTMENTS
The solenoid mounting plate of the Paper Feed
Controller Assembly should be located so that
controllers A, B, &Dare each 1.0 ±0.4 mm when
lifted from these clutch-action rings, as shown in
Fig. 480.
+0 8
1 —0.4 ~~)
Controller
~~
Clutch-action Ring
Fig. 4-80 Controller Spring
If this spacing is not correct, change the solenoid mounting plate position until these para-
meters are met.
4) PICKUP ROLLER SPACING ADJUSTMENTS
The spacing of the rubber pickup rollers on their shaft should correspond to the measure-
ments given in Fig. 4-81. Should any adjustment be necessary, loosen the setscrew secur-
ing the roller to the shaft, and slide the roller to the correct position; then, resecure the
roller.
C
228±4
148±3
35±2 —~
183±2
Pickup Rubber Roller
Pickup Roller Shaft
Fig. 4-81 Pickup Roller Spacing
Roller Sprock
Setscrew
l
Roller Core
© CANON INC..
Second Printingtilune, 1974