Canon NP-70 Service Manual page 178

4-76
NP•70
4.11-3
REMOVAL/INSTALLATION ACTIONS
1) COPY CONVEYING ASSEMBLY REMOVAL
When access to internal components within the copier is desired it is often necessary to re-
move this assembly. Perform the removal as follows:
a) Switch OFF the power and detach the rear cover of the copier.
b) Remove the copy tray and the paper cassette.
c) Open the front left and upper access doors and lower the Copy Conveying Assembly by
disengaging its hanger stay from the locking hook.
d) Remove the Drum Assembly.
e) Remove the Transfer Corona Assembly and the Paper Separating Subassembly.
fj Raise the Copy Conveying Assembly back to its original position and remove the Heater
Assembly.
g) Disconnect the high-voltage connector of the Transfer Corona Assembly, and put it into
the Copy Conveying Assembly.
Delivery
Roller 2
Hanger Stay
Upper Left Crossmember
L -
Delivery Roller 1
Eliminator Ass'y
Timing Roller
Heater Ass'y
Fig. 4-90 Copy Conveying Assembly (from copier front)
Separation Roller
Corona Ass'y
Blower Ass'y =
Pivot Shaft
Second Printing-June, 1974
© CANON INC.