Fig. 491 Pivot Shaft Removal - Canon NP-70 Service Manual

NP-70
4-77
h) Remove connector J 17 and place it into the Copy Conveying Assembly.
i) Loosen the retaining screw of the stopper on the pivot shaft.
j) While holding the assembly in the raised position, draw out the pivot shaft.
k) Lower the assembly by disengaging its hanger stay from the locking hook.
1) Remove the Copy Conveying Assembly from the copier.
n►) Pick up the stopper and spacer which were detached during the process of drawing out
the pivot shaft.
Retaining Screw
Copy Conveying
Assembly
Stopper
Spacer
Fig. 4-91 Pivot Shaft Removal
Pivot Shaft
Retaining Washer
Copier Front Plate
2) COPY CONVEYING ASSEMBLY INSTALLATION
To place the Copy Conveying Assembly back in the copier after maintenance is completed,
perform the following:
a) Place the Copy Conveying Assembly back in position in the copier, setting its hanger stay
on the locking hook (to raise the assembly).
b) Insert the pivot shaft through the hole in the front mounting plate.
c) Put the spacer between the front mounting plate and the Copy Conveying Assembly and,
then, insert the pivot shaft through this spacer.
d) Push the shaft through the front-side shaft hole of the Copy Conveying Assembly and
then through the stopper.
© CANON INC. Second Printing-June, 1974