Fig. 4-22 Adjust Line Replacement (C); Fig. 4-23 Adjust Line Replacement (D) - Canon NP-70 Service Manual

4-18
NP•70
e) Turn the aperture adjust ring counterclockwise (ccw) until the stud of the ring is at the
extreme left position.
f)
After passing the line in the groove over and around the aperture adjust ring, loop the line
one time around the ring stud and, then, pass it again around the ring (see Fig. 4-22).
e
Pulley
Fig. 4-22 Adjust Line Replacement (Cj
Aperture Adjust
ng (max-ccw)
g) Check whether the apeture adjust ring is at its most extreme ccw position when the ex-
posure dial is set at 9. If not, it is easily adjusted by loosening the three retaining screws
on the side of the dial pulley and, then, turning the aperture adjust ring ccw until the ex-
posure dial is at 9. The complete installation is seen in Fig. 423.
Retaining
Screws
Dial Pulley
Exposure
Adjust Line
Tension
xposure Dial
Idler Pulley
pring
Fig. 4-23 Adjust Line Replacement (DJ
Lens Unit
Aperture Adjust Ring
a
f
Second Printingtilune, 1974
© CANON INC.