1.4 Operating Procedures; Preparation; Placing Of Original; Loading Of Paper - Canon NP-70 Service Manual

1-6
NP -70
1.4 OPERATING PROCEDURES
1.4-1
PREPARATION
1) After setting the ON/OFF Switch to ON, the Power Lamp will light up and the Ready lamp
will flash. At this time the doors must be closed. Also, make sure that the starting position-
ing mark on the copyboard aligns with the starting mark on the control panel.
2) In 2 minutes the Ready lamp will go out to indicate that the copier is ready for operation;
while the Ready lamp flashes, copying operation can be performed, but the copy obtained will
not be dried completely.
1.4-2 PLACING OF ORIGINAL
Lift up the copyboard cover and place the original face down on the copyboard glass, flush
against the appropriate copy-size indicator. Then, lower the copyboard cover over the original.
1.4-3 LOADING OF PAPER
1) Pull out the paper cassette and take off the cassette cover.
2) Fan the paper (specified copy paper) well, to separate any sheets which might be stuck to=
gether.
3) Load the paper so that its end is flush to the rear end of the inner plate of the cassette.
4)
Gently push down the right and left ends of the paper and insert under the separation hooks.
5) After loading, place the cover on the cassette in an open condition and push the paper cassette
firmly into position in the copier.
1.4-4 COPYING OPERATIONS
1)
25 COPIES OR LESS
Set the copy dial for the desired number of copies. Then, after pressing the COPY button, the
required number of copies will be produced, with the copier automatically stopping after the
last sheet.
2) MORE THAN 25 COPIES
After noting the number indicated by the counter, set the copy dial to "M"and press the COPY
button. When the counter registers the required number, press the stop button. The duplicat-
ing will come to a stop.
Second Printing-June, 1974
©
CANON INC.