Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for NCR 7761-K130
Summary of Contents for NCR 7761-K130
- Page 1 KIT INSTRUCTIONS 4GB/8GB Memory Upgrade 7761-K130/K131/K132 Issue B...
- Page 2 NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
- Page 3 Revision Record Issue Date Remarks May 2017 First Issue Mar 2018 Added K132 Added Columbus 900 Installation Instructions...
- Page 4 4GB/8GB Memory Upgrade Introduction This kit provides a 4GB/8GB DDR3 Memory for any of the following POS terminals: • P1535 • P1235 • P1532 • Columbus900 Kit Content Kit Number Part Number Description 7761–K130 497–0505658 Memory Module – 4GB, 1600MHz DDR3L- 1600,512Mx64 SODIMM 7761–K131 497–0514577...
- Page 5 7761-K130/K131/K132 (Memory Upgrade) Installation Procedure Refer to the appropriate sections for your POS terminal: • P1535/P1235/P1532 POS on the facing page • Columbus 900 POS on page 4...
- Page 6 7761-K130/K131/K132 (Memory Upgrade) P1535/P1235/P1532 POS 1. Open the Head Assembly. 2. Access the memory modules on the Back Housing Assembly. 3. Open the latches at the ends of the memory socket to release the module. 4. Remove the module. 5. Install the new 4GB/8GB memory module by aligning it with a socket and pushing it into the socket (the socket is keyed).
- Page 7 7761-K130/K131/K132 (Memory Upgrade) Columbus 900 POS Memory configurations containing a single memory module should be installed in the lower socket (Socket 1) and Memory expansions are installed in the upper socket (Socket 1. Tilt the Display backward. 2. Slide the Front Cover upward to remove it from the stand.
- Page 8 7761-K130/K131/K132 (Memory Upgrade) 3. Loosen two thumbscrews and open the I/O Door. 4. Insert the Memory Module into the socket at an angle and then press the module towards the Motherboard until it latches in position.
Need help?
Do you have a question about the 7761-K130 and is the answer not in the manual?
Questions and answers